Call us: +44 (0)1634 300900 | E-mail: sales@dpie.com

Diamond Point International

Kontron CPS3-SVE-S300AC - 3U 8 HP Wide-Range PSU, 90 to 264 VAC, 300 W

SSI-type Rear Connector, for Railway Systems, -40 to +70°C Operating Range

Kontron CPS3-SVE-S300AC - 3U 8HP PSU, 90-264 VAC, 300W
Key Features
300W AC PSU for CompactPCI® Serial
3U, 8HP board
Input voltage range of 90 to 264 VAC
Output power 300 W (requires fans)
Holdup time 20ms minimum
SSI-type rear connector
-40 to +70°C operating range

Introduction

Flexible usage

CPS3-SVE-S300AC is a 300 Watt power supply is flexible for many operational conditions. It has a wide input range of 90-264 VAC, and operates under extended temperature from -40°C to +70°C at full rating. It provides 12V output and 5V standby as defined for CompactPCI® Serial.

Advanced feature set for high system reliability

CPS3-SVE-S300AC provides the full feature set as recommended by the CompactPCI® Serial community, including the rear connector. Redundancy and hot-plug, several protection and regulation features, advanced monitoring functions via I²C/PMBUS as well as its hold-up time make the power supply a reliable backbone of every CompactPCI® Serial platform.

Easy system integration and field maintenance

Integration by hot-plug from the frontside to a backplane connector - no cabling, no power down of redundant systems - this makes the application more reliable and maintenance in the field an easy matter.

Specification

Power Supply

InputAC Input Voltage: 90 - 264 VAC
Input Frequency: 50 - 440 Hz
EMI Filter: EN55022 Class B, FCC Part 15
Inrush Current: 32A at 230 VAC
Input Current: 1.3 A
Isolation: 4242 VDC (input to output)
Leakage: <0.3mA
Output(s)DC Output: Power Maximum continuous output power 300W full rating, with 20CFM fan cooling required
Output Voltage: 12V
Auxiliary Supply: 5V/2.5A
Hold Up Time: 20 ms min.
Temperature Coefficient: +-0.01% / °C
Long Term Stability: 0.01% after 20 minutes warm-up
Output Current: 0A min., 24A max.
Load Regulation: +-1%
Line Regulation +-0.5%
Ripple & Noise: 1% Pk to Pk
Transient Response: 2% Maximum deviation; returns to initial conditions in 1 msec max.
Efficiency: 90% (for 220 VAC)
Active PFC: 0.99
Switching Frequency: 134 KHz
ORing FET: Provided for redundant operation
Active Current Share (S2): 12V Output will current share within 5% when interconnected by a single wire
Passive Current Share: 5V SBY droop type
IsolationIsolation (according to EN 50155)
• Input/output: 3100 VAC
• Input/shield: 3100 VAC
• Output/shield: 1000 VAC
According to EN 60950-1
OtherOverload Protection: The feature will reduce the output voltage to a safe dissipation level when the output power rating exceeds 125% of maximum rated power. The unit will automatically return to regulation upon removal of the overload.
Overvoltage Protection: Set at 115% to 135%. Latching method (recycle AC to restart)
Short-circuit Protection: The units will withstand a continuous short without damage, it will automatically return to regulation upon removal of the short
Thermal Protection: Yes, built in thermal sensor to protect abnormal temperature conditions
Remote Sensing: (R2/E3) On 12V output only
PS_ON (F3): Digital input: A logic low enables the main output, a low shall not source > 1 mA
Enable (R6:) Digital input: when driven high, main output is disabled, when low, main output state is as controlled by PS_ON
FAL/PWR_FAIL (U2): Digital output, Open Collector, driven high when outputs are in regulation. It will go low minimum 1 ms prior to output going out of regulation
DEG (U5): Digital output, Open Collector, temperature warning signal. A TBD temperature will change signal state from Hi to Low or Low to Hi
(programmable preferences)
PS Present (H3): Digital Output, pulled low via 100 Ohm resistor
I²C / PMBUS: Monitors temperature, output voltage, and output current; connects to a serial NVRAM which is programmed with serial number, PMBUS
Standard to allow monitoring of overall operation of power supply
LED Indicators: Bicolor LED: Green LED: all outputs operating within specifi cations, Red LED: power supply out of specifi cation

General

ElectricalSee above
MechanicalDimensions: 3U, 8HP, 169.4 x 128.5 x 40.3 mm including face plate and connector
Connector: Connector SSI-type connector (FCI 51939-667 or identical). The mating connector is either included in the CompactPCI® Serial backplane, or available with a one-slot power backplane to be mounted into the chassis and connected to the CompactPCI® Serial backplane
TemperatureTemperature range (operation): -40 to +70°C (continuous duty, full rating)
20CFM forced air cooling required
HumidityUp to 95% non-condensing
Weighttbd
Safety/CertificationTo be submitted: UL 60950-1 2nd Edition, UL508. CUL 60950-1 2nd Edition, UL508. DEMKO EN60950-1 2nd Edition; CE
Warranty2 Years
RoHSCompliant

Ordering Details

BoardCPS3-SVE-S300AC
CompactPCI® Serial Power Supply 3U 8HP, 300W, 90-264 VAC, nominal voltage /max current: +12V/24A, 5VSB/2.5A.
Operating -40°C to 70°C full load. Hold-up time min 20ms. Supports hot-plug and redundant operation. Monitoring and
control functions (I²C/PMBUS). Frontpanel with bicolor status LED. Forced air cooling required.
AccessoriesCPS3-BPP
3U CompactPCI® Serial Power Backplane, one slot backplane for the SSI-type power connector as specifi ed for CompactPCI® Serial