Call us: +44 (0)1634 300900 | E-mail: sales@dpie.com

Diamond Point International

Kontron CP3010-SA - 3U cPCI/CompactPCI® Intel® Atom™ CPU Board

Up to 8 GB DDR3L SDRAM, up to -40 to +85°C Operation

Introduction

The CP3010-SA Kontron's latest low-power 3U CompactPCI® CPU board supports the Intel® Atom™ processors E3826 and E3845 with a maximum of quad-core 1.91 GHz processing performance. Even though the board
design is based on Atom™ technology, performance levels of former Core™ 2 Duo platforms can be reached.
Further, the built-in graphics core now features Intel® HD Graphics Technology offering an outstanding increase in graphics performance compared to previous Atom™ designs.

Memory demanding applications can make use of up to 8GB soldered DDR3L running at 1333MHz. For onboard data storage the CP3010-SA offers a CFAST option or a soldered SATA Flash and a HDD/SSD option on the 8HP extension module.

Specification

CPU

CPU SpecIntel® Atom™ SOC (22nm technology):
E3845: Quad-Core 1.91 GHz, 2MB cache
E3827: Dual-Core 1.75 GHz, 1MB cache
ChipsetIntegrated
MemoryUp to 8GB soldered DDR3L running at 1067/1333 MHz, dual channel w/o ECC
GraphicsIntel® Gen7 Graphics, OpenGL 3.0, OpenCL 1.2, DX11, H.264, MPEG2, MCV, VC-1, VP8
NetworkUp to three 1000BASE-T interfaces with WOL (Wake-on-LAN) support, two front/rear switchable, third available via 8HP extension, Intel® I210-IT Ethernet controller
StorageOnboard CFast installation via CFAST module
Up to 64GB soldered SATA NAND Flash, optional available
Onboard 2.5" SATA SSD/HDD installation via 8HP extension
Two SATA 3 Gb/s ports via rear J2
Front I/OFront Interfaces 4HP
• DisplayPort: 2x 20-pin DisplayPort connectors, DVI/HDMI/VGA capable through cable adapter
• USB: 1x USB 3.0 port, 9-pin type-A connector, 1x USB 2.0 port, 4-pin type-A connector
• Ethernet: 2x RJ-45 with integrated LEDs (ACT, SPEED)
• LEDs: 6x LED’s: 4x POST Code or General Purpose, WD, TH

Front Interfaces 8HP (additional to 4HP)
• Ethernet: 1x RJ-45 with integrated LEDs (ACT, SPEED)
• CAN: 1x 9-pin D-Sub connector
• Serial Port: 1x 16C550-compatible serial port, RS-232 signalling, RJ-45
• USB: 1x USB 2.0 port, 4-pin type-A connector
• Line-In: 1x 3.5 mm stereo jack, blue jack
• Line-Out: 1x 3.5 mm stereo jack, green jack
• Control: Reset button and HDD activity LED
Rear I/ORear I/O via J2 The CP3010-SA supports the following interfaces via Rear I/O:
• One VGA analog port
• Two USB 2.0 ports
• Two Gigabit Ethernet ports without LED signals
• Two SATA 3 Gb/s ports
• Two COM ports RS-232 (LVTTL signal level)
• Five GPIs and Three GPOs (LVTTL signal level)
• System management signals: Power Button, Sleep S3, 5V Standby
• Option to write protect non-volatile RAMs via a special pin
OtherHigh-Speed Extension Connector
• One 60-pin high-speed connector holding:
• COMA (TTL)
• One SATA 3Gb/s
• One USB 2.0
• PCIe x1
• HDA
• XBUS
• Reset

Hot Swap: Support for all signals to allow peripheral boards to be hot swapped. The individual clocks for each slot and access the backplane ENUM# signal comply with the PICMG 2.1 Hot Swap Specifi cation
BIOSTwo redundant 8 MB SPI boot fl ashes with fail-over functionality
Phoenix uEFI, setup console redirection to serial port (VT100 mode) with CMOS setup access, EFI Shell support, board confi guration via Shell, diskless, keyboardless, videoless operation
OptionsWatchdog: FPGA-based, timeout ranging from 125ms to 4096s programmable in 16 steps, IRQ, reset, dual-stage confi guration
RTC: Integrated in SOC
Trusted Platform Module (TPM): Atmel AT97SC3204 TPM 1.2 controller
CAN: SJA1000 CAN controller for one CAN port, available on the 8HP extension

General

ExpansionPICMG 2.0 Rev. 3.0 compatible, 32-bit/33MHz (66MHz on request), version with rear I/O via J2
Universal 5V and 3.3V PCI signalling voltage supported, 7 Req/Gnt & clock lines
Operating in system slot as system master and in peripheral slot in PCI passive mode
CompactPCI® Core Specifi cation PICMG 2.0 Rev. 3.0
CompactPCI® Hot Swap Specifi cation PICMG 2.1 Rev. 2.0
ElectricalSupply voltage/power consumption:
• +5.0V (4.85 V min. to 5.25 V max)
• +3.3V (3.2 V min. to 3.47 V max)
• +5.0V STDBY (optional, 4.85 V min. to 5.25 V max)
• Intel® Atom™ E3845 1.91 GHz: 14.3W max, 9.4W typical, 7.8W idle
• Intel® Atom™ E3827 1.75 GHz: 11.6W max, 8.6W typical, 7.8W idle
MechanicalDimensions: conforming to CompactPCI® specification for 3U boards
Front panel: 4HP or 8HP with ejector
Conformal Coatingon request
SoftwareSupport for Windows® 7, Windows® Embedded Standard 7, Windows® 8, Linux, VxWorks®, QNX®
TemperatureTemperature range (operation):
• 0 to +60°C standard
• -40 to +85°C extended temperature E2
Temperature range (storage): -40 to +85°C
Humidity93% RH at 40°C, non-condensing (acc. to IEC 60068-2-78)
Weight4HP: ca. 350g
Warranty2 Years
RoHSCompliant

Ordering Details

UpdateNovember 2015 - Kontron have notified us that they have five CP3010-SA-1.75D-4-4R-T-E2-c (CP3010-SA Atom 1.75GHz Dual Core, 4GB, 4HP, Rear IO,TPM, E2, Coating) ready to ship
BoardCP3010-SA-1.91Q-4-4F-T
Atom™ E3845, 1.91 GHz, 2MB cache, 4GB DDR3L, 4HP, Front I/O

CP3010-SA-1.91Q-4-4R-T
Atom™ E3845, 1.91 GHz, 2MB cache, 4GB DDR3L, 4HP, Rear I/O

CP3010-SA-1.91Q-4-8F-T
Atom™ E3845, 1.91 GHz, 2MB cache, 4GB DDR3L, 8HP, Front I/O, HD/SSD/CFast Carrier

CP3010-SA-1.75D-4-4F-T
Atom™ E3827, 1.75 GHz, 1MB cache, 4GB DDR3L, 4HP, Front I/O

CP3010-SA-1.75D-4-4F-T-E2
Atom™ E3827, 1.75 GHz, 1MB cache, 4GB DDR3L, 4HP, Front I/O, ext. Temp.
AccessoriesCP-RIO3-04 4HP rear I/O module (2x Ethernet, 2x USB, VGA, 2x SATA connectors)
CP-RIO3-04 8HP rear I/O module (additional to 4HP COMA/B)
CP-RIO3-04S 4HP rear I/O module (2x Ethernet, COM, VGA, 2x SATA connectors)

Need storage - try Innodisk SSD