Diamond Point International

Sitemap - Print Page - Email Link - RSS News Feed RSS

 
Men Mikro

Men Mikro F606

3U CompactPCI® Side Card Gb Ethernet

4 HP Extension For 3U Intel® SBCs F14, F15, F17, F18
 
Men Mikro F606 3U CompactPCI Side Card XMC/PMC
  
  • 4 HP extension for MEN Boards
  • 2 Gigabit Ethernet Controllers
  • Uses Lemo railway compliant connectors
  • 1 COM extension (SA-Adapter™)
  • -40 to +85°C screened
  • Conformal coating
  • 2.5" SATA hard disk slot



Datasheet/Manual:

MEN F606 datasheet in PDF format Datasheet in PDF format
Manual available on request Manual available on request

 

Introduction

The F606 is a 4HP dual Gigabit Ethernet extension card for 3U Intel® based CompactPCI® single-board computers such as F14, F15, F17, F18 and further boards of the Intel® low power family.

Equipped with rugged Lemo connectors the F606 makes Gigabit Ethernet connectivity available for applications in railways and other harsh and mobile environments. An individually configurable UART is accessible via D-Sub connector. Consequently, this side card is screened for -40 to +85°C operation temperature and comes with conformal coating. The F606 is directly plugged to the right side of the respective single-board computer. A robust connector makes for high mechanical stability. It is delivered with an 8HP front panel, replacing the 4HP front panel of a 3U single-board computer and thus resulting in a solid one-piece front panel.

Options of the F606 allow to replace the Lemo by D-Sub connectors and may provide up to two UART channels on the front and up to two USB ports via rear I/O.
 
 

Specification
I/O:

Ethernet
o Two 10/100/1000Base-T Ethernet channels
o Lemo connectors at front panel
o Ethernet controllers are connected by two x1 PCIe® links
o Two on-board LEDs for each channel to signal LAN Link, Activity status and connection speed

UART
o One at front panel
o Physical interface using SA-Adapter™ via 10-pin connector
o RS232..RS422, isolated or not
o Data rates up to 1 Mbit/s
o FIFO receive and transmit buffers for high data throughput
o Handshake lines: full support; lines depend on SA-Adapters™
o SA-Adapter™ has to be installed at the factory
Mass Storage:

Serial IDE (SATA)
o One port for on-board 2.5" hard-disk drive
o Transfer rates up to 150MB/s (depends on hard disk)
o RAID level 0/1 support (depends on CPU board)
Miscellaneous:

CompactPCI® J1 is assembled for increased mechanical stability and/or for power supply
Electrical:

Supply voltage/power consumption:
o +5V (-3%/+5%), 600mA typ. (w/o hard disk)
o +3.3V (-3%/+5%), 1.6A typ. (w/o hard disk)
MTBF: 1,290,994h @ 40°C according to IEC/TR 62380 (RDF 2000)
Mechanical:

Dimensions: conforming to CompactPCI® specification for 3U boards
Mountable on right (standard) or left (option) side of the CPU
Weight: 150g (w/o hard disk and SA-Adapters™)
Environmental:

Temperature range (operation):
o -40..+85°C
o Airflow: min. 10m³/h
Temperature range (storage): -40..+85°C
Relative humidity (operation): max. 95% non-condensing
Relative humidity (storage): max. 95% non-condensing
Altitude: -300m to + 3,000m
Shock: 15g/11ms
Bump: 10g/16ms
Vibration (sinusoidal): 1g/10..150Hz
Conformal coating on request
Safety:

PCB manufactured with a flammability rating of 94V-0 by UL recognized manufacturers
EMC:

Tested according to EN 55022 (radio disturbance), IEC1000-4-2 (ESD) and IEC1000-4-4 (burst)
Software Support:

Driver software can be found in the data sheet of the CPU board that you use.
ROHS Status:

This product is lead free/ROHS compliant.

Ordering Details:
Board:

02F606-00 2 Gigabit Ethernet on Lemo railway compliant connectors, 1 COM extension (SA-Adapter™ not included), SATA hard disk slot, for F14 and compatible SBCs, conformally coated, -40...+85°C screened

Please refer to datasheet for further information.
Accessories:

N/A
Further Information:

Want further information or pricing on this product? Either fill out our feedback form or contact us for further information.
 
© 2008 Diamond Point International. All rights reserved.