Diamond Point International

Sitemap - Print Page - Email Link - RSS News Feed RSS

 
MEN Mikro

MEN Mikro 0701-0056

3U CompactPCI® Plus 4U / 84 HP 8 Slots Single Euro Hybrid

For MEN SBCs F12N, F13, F14, F15, F17, F18, F19P & F50P, 19" Rack Mountable
 
MEN Mikro 0701-0056 4U CompactPCI Serial 4U / 84 HP System
  
  • 19" rack-mountable
  • IEEE 1101.10/11 compliance
  • 4U / 84 HP system (incl. 1U fan tray)
  • 8-slot hybrid backplane
  • 4 CompactPCI® Plus (PICMG CPLUS.0)
    peripheral slots to the right
  • 4 CompactPCI® (PICMG 2.0, 2.30) slots to the
    left
  • All slots prepared for rear I/O
  • 250 W Plug-in PSU 90..264 VAC
  • 44HP space for individual extensions
  • For MEN SBCs F12N, F13, F14, F15, F17, F18,
    F19P, F50P



Datasheet/Manual:

MEN 0701-0056 datasheet in PDF format MEN Mikro 0701-0056 Datasheet - PDF
Manual available on request Manual available on request

 

Introduction

This compact 4U rack-mount enclosure is a basic system that allows the configuration with both CompactPCI® Plus and CompactPCI® cards. Being a hybrid system, it offers an uncomplicated and cost-effective migration solution from parallel 3U CompactPCI® to serial CompactPCI® Plus.

The 8-slot hybrid backplane in this configuration does not need a bridge or an active logic. The four slots on the left are designed for 32-bit CompactPCI® and rear I/O on P2. The four slots on the right are reserved for CompactPCI® Plus. The CompactPCI® PlusIO system slot is the fourth slot from the left. Either a standard CompactPCI® 2.0 or a PICMG 2.30 CompactPCI® PlusIO CPU board can be used in this slot. The CompactPCI® Plus slots on the right can only be used with a CompactPCI® PlusIO board, however.

This hybrid system is designed for use with the MEN system-slot SBCs F12N, F13, F14, F15, F17, F18, F19P and F50P. Only F19P and F50P support CompactPCI® Plus. That way, the three remaining slots on the CompactPCI® bus and the four CompactPCI® Plus slots can be used to install additional I/O functions.

While the serial CompactPCI® Plus slots on the right are best suited for functions like Gigabit Ethernet, 10 Gigabit Ethernet or high end graphic with high data rate requirements, the parallel CompactPCI® bus delivers enough performance for all kinds of conventional I/O like binary or analog signals. In addition, the system offers space for mass storage devices.

A 8HP plug-in 250W power supply unit which is accessible at the back of the system is already included and wired.

The enclosure meets EMC requirements, making it a perfect choice for embedded applications in harsh environments.

Ask us for completely configured, wired and tested systems!

MEN Mikro 0701-0056 backplane
Backplane used inside rack.
 
 

Specification
General System Characteristics:

Compliance with IEC 60 297-3, IEEE 1101.10
8 slots for 3U Eurocard boards (4 CompactPCI® Plus slots)
Mechanical:

19" rack-mount standard
3U card vertical
Dimensions: 3U, 84HP, 278mm depth
Weight: tbd.
CompactPCI®/CompactPCI® Plus Backplane:

8-slot
CompactPCI® PlusIO System slot on the fourth slot from the left

  • Support of four CompactPCI® Plus peripheral slots

Three CompactPCI® peripheral slots
Four CompactPCI® Plus peripheral slots
Power Supply:

Plug-in power supply

  • 3U/8HP
  • 250W
  • 90V..264V AC wide range
  • 3.3 V/40A, 5 V/40A, 12V/5.5A, -12 V/2A
  • 3U power backplane with P47 receptacle
  • 3U power input module with IEC input, fuse holder, line filter and power switch

Power connector and power-on switch at the back
1U fan chassis:

Two vertical fans

  • 12V
  • Air flow volume 140 m³/h (manufacturer's data)
  • Dimensions 119 x 119 x 32 mm
  • Sound pressure level 39 dB(A)
Environmental:

Temperature range (operation): 0..+50°C
Temperature range (storage): o -40..+85°C
Relative humidity (operation): max. 95% non-condensing
Relative humidity (storage): max. 95% non-condensing
Altitude: -300m to + 3,000m
Shock: 15g/11ms
Bump: 10g/16ms
Vibration (sinusoidal): 2g/10..150Hz
EMC:

Tested according to EN 55022 (radio disturbance), IEC1000-4-2 (ESD) and IEC1000-4-4 (burst)
Compatibility:

Suited for MEN Boards...
F12N - CompactPCI® MPC5200B SBC
F13 - CompactPCI® MPC8540 SBC
F14 - CompactPCI® Pentium® M SBC
F15 - CompactPCI® Core Duo SBC
F17 - CompactPCI® Core 2 Duo SBC
F18 - CompactPCI® Core 2 Duo SBC
F19P - CompactPCI® PlusIO Core 2 Duo SBC
F50P - CompactPCI® PlusIO MPC8548 SBC
ROHS Status:

This product is lead free/ROHS compliant.

Ordering Details:
Board:

0701-0056
CompactPCI/CompactPCI Serial 19" 4U/84HP rack-mount enclosure for 3U cards (vertical), 4+4-slot 3U CompactPCI / CompactPCI Serial hybrid backplane, prepared for rear I/O, 250W power supply wide range 90..264VAC on rear, 1U fan tray with 2 fans included, 0..+60°C

Please refer to datasheet for further information.
Accessories:

02G020-01 Intel Core i7-610E, 2.53 GHz, 4 GB DDR3 DRAM with ECC, 0 to +60°C
02G211-00 4 1000Base-T Ethernet interfaces, 4 RJ45 connectors at front, 0 to +60°C screened
02G211-01 4 1000Base-T Ethernet interfaces, 4 M12 connectors at front, -40 to +85°C screened
02G212-00 compactPCI Serial 2 PCI Express MiniCard slots (USB and PCIe), -40 to +85°C screened
02G213-00 compactPCI Serial PMC/XMC carrier board, -40 to +85°C screened
02G501-00 compactPCI Serial SATA HDD/SSD carrier, -40 to +85°C with qualified components
Further Information:

Want further information or pricing on this product? Either fill out our feedback form or contact us for further information.
 
© 2012 Diamond Point International. All rights reserved.