Call us: +44 (0)1634 300900 | E-mail: sales@dpie.com

Diamond Point International

Connect Tech Xtreme I/O Opto - 48-line Isolated Digital I/O PCI-104 Module

48 Digital I/O Lines, 3 16-Bit Counter / Timers

Introduction

Connect Tech’s Xtreme I/O Opto is a 48-bit isolated PCI-104 Digital I/O board grouped with 24 optically isolated inputs and 24 optically isolated outputs. The flexibility of the FPGA technology allows integration and customization to meet application requirements.

Fully PCI-104 compliant, Xtreme I/O Opto Digital I/O can be controlled directly from a memory mapped register set in any operating system.

The reliability of the Xtreme I/O Opto, along with the added protection provided by 3kV isolation on the Digital I/O ensures optimal performance and protection under extreme environmental conditions. Xtreme I/O Opto is ideal for PC/104 and other embedded technology applications in the military, aerospace, medical and industrial sectors.

Xtreme I/O Opto PCI-104 Digital I/O Features and Benefits

  • Inputs: Selectable interrupt generation on any input signal (change of state, rising or falling edge) with 1.8kOhm current limiting series resistor on each input, and wide input voltage range from +0 up to +40V DC
  • Outputs: Individual selectable output voltage levels with a 4.7kOhm pull up, with maximum output current of 8mA, and wide input voltage range from +0 up to +40V DC
  • Flexibility: FPGA Register Controlled Device (jumpers are not required)
  • Optical Isolation: 3kV RMS

Specification

Digital I/O/Counter/Timers

I/Os24 optically isolated inputs (24-bits)
24 optically isolated outputs (24-bits)
InputsWide input voltage range from +0 up to +40V DC
Independent grounds and reverse voltage protection
Selectable interrupt generation on any input signal (change of state, rising or falling edge)
1.8kOhm current limiting series resistor on each input
OutputsWide output voltage range from +0 up to +40V DC
Open collector configuration with common emitters
Individual selectable output voltage levels with a 4.7kOhm pull up
Maximum output current: 8mA
Isolation3kV RMS
Connectors(s)2x25 (50 position) 0.1” (DIL) pin headers available in vertical or right angle
OtherControl/Addressing:
• FPGA Register Controlled Device (No jumpers needed)
• Custom logic available upon request

General

ExpansionPCI-104 (32 bit) interface, stack-though connector fitted.
PC/104 (16 bit ISA) connectors can optionally be installed for pass-through operation
ElectricalPower Input: +5VDC +/-5%
MechanicalDimensions: 96mm x 90mm
Conformal CoatingOn request
SoftwareCustom CTI Device Drivers for QNX, Linux, Windows
Device can also be controlled directly from a memory mapped register set in any operating system
TemperatureTemperature range (operation): -40ºC to +85ºC (-40ºF to +185ºF)
Temperature range (storage): -40ºC to +85ºC (-40ºF to +185ºF)
Humidity0-90% non-condensing
Weight2.8 oz/79g
WarrantyLifetime
RoHSCompliant

Ordering Details

BoardDAG001
Xtreme/IO 24 inputs and 24 outputs of Digital I/O. 0-+40V input voltage, PCI-104. 3kV Optical Isolation
AccessoriesN/A