Call us: +44 (0)1634 300900 | E-mail: sales@dpie.com

Diamond Point International

Connect Tech SSD/104 - PCIe-104/PCI-104 Dual mSATA Drive Carrier

Supports up to Two mSATA SSD Modules, Different Bus Interfaces Available

Introduction

Connect Tech’s SSD/104 SATA is a complete rugged stackable solid state drive (SSD) and storage solution that allows up to two mSATA SSD modules to be installed into any PC/104-Plus, PCI-104, PCI/104-Express and PCIe/104 stack or embedded system. SSD/104 SATA solid state drive (SSD) and storage solution improves performance, expands storage capacity and reduces overall storage footprint in an embedded system.

Designed with the latest generation of mSATA SSD modules, SSD/104 SATA solid state drive (SSD) and storage solution can be easily upgraded to accommodate future generations of mSATA modules for even greater system capacity and performance.

When combined with mSATA SSD modules, SSD/104 SATA solid state storage solution directly interfaces with the standard SATA bus, which can be used as a drop-in replacement for any SATA storage device. SSD/104 SATA can also be interfaced with any single board computer or embedded system using standard 7-pin SATA.

SSD/104 SATA is available as a complete storage solution with a preinstalled mSATA module, or as a separate mSATA carrier which supports any mSATA SSD module.

Build Options:

  • PCI/104-Express: Both PCIe/104 and PCI-104 stacking connectors installed
  • PCIe/104: Only the PCIe/104 stacking connector is installed
  • PCI-104: Only the PCI-104 stacking connector is installed
  • No Bus: No stacking bus connectors installed

SATA signals can be accessed either via PCIe/104 bus or via standard SATA connector. Note that this choice is a factory option and varies depending on SKU.

Specification

Storage Specification

Model InfoUp to 2 mSATA SSD modules
Uses any available mSATA drive
Cable-Free Operation: SATA signals from PCIe/104 or PCI/104-Express Type 2 SBC
ConnectorStandard Right Angle 7-pin SATA data connectors
mSATA Connectors
3.5mm pitch Phoenix Type power connector
PCI-104 or PCIe/104 stacking connectors (optional)
CapacityUp to 1TB mSATA modules (limited by commercially available modules)
Data SecurityNot supported
OtherSupports all SATA generations:
• SATA I - 1.5Gbps 150MB/s
• SATA II - 3Gbps 300MB/s
• SATA III - 6Gbps 600MB/s
• Compatible with any SBC SATA port

Build Options
• PCI/104-Express (SDG001): Both PCIe/104 and PCI-104 stacking connectors installed
• PCIe/104 (SDG002): Only the PCIe/104 stacking connector is installed
• PCI-104 (SDG003): Only the PCI-104 stacking connector is installed
• No Bus (SDG004): No stacking bus connectors installed

General

ExpansionDepends on module:
PCI/104-Express (SDG001): Both PCIe/104 and PCI-104 stacking connectors installed
PCIe/104 (SDG002): Only the PCIe/104 stacking connector is installed
PCI-104 (SDG003): Only the PCI-104 stacking connector is installed
Electrical+3.3V / 0.5A maximum through PCIe/104 bus, PCI-104 bus or external connector
Supply Voltage: +3.3V ±5%
Low Power Consumption: 260mA (Active) / 130 mA (Idle)
Mechanical3.550” x 3.775” (90.17mm x 95.89mm), PC/104 Compliant
Conformal CoatingOn request
SoftwareN/A
TemperatureTemperature range (operation): -40ºC to +85ºC (-40ºF to +185ºF)
Temperature range (storage): -40ºC to +85ºC (-40ºF to +185ºF)
Humidity0-90% non-condensing
WarrantyLifetime
RoHSCompliant

Ordering Details

BoardSDG001 SSD/104 mSATA carrier with both PCIe/104 and PCI-104 stacking connectors installed
SDG002 SSD/104 mSATA carrier with PCIe/104 stacking connector installed
SDG003 SSD/104 mSATA carrier with PCI-104 stacking connector installed
SDG004 SSD/104 mSATA carrier with no stacking bus connectors installed

Note: All these have SATA signals routed via standard SATA connector. Contact us for versions where SATA signals are routed from PCIe/104 bus (or refer to manual for jumpers to change).
AccessoriesN/A